Blog Post

Gas Cutting Equipment: Using the right Cutting Torch

Cutting torches, a technique that combines a fuel gas and oxygen to cut metals, are frequently used by welders, plumbers, and many other building and fabrication crafts. 

In order to cut through metals, like a gas cutting equipment in UAE with a specially made tip is connected to a fuel tank, usually one of three popular fuel substitutes or acetylene. The fuel is mixed with oxygen in the torch and produces a high-temperature flame cone.

In this blog, let’s find out how to find the right cutting torch for your work.

Tips to Choose the Right Cutting Tip:

Performance and safety depend on using the right cutting tip for the task. Using the procedure below makes it simple, but you must be aware of these four aspects of your project and machinery:

1. Seat Type

The brand determines this. The type of seat depends on the brand or model of your torch and/or the part number of the cutting tips you want to replace.

If this crucial phase is neglected, the machinery may be harmed or dangerous combustible gas leaks may occur. With different torch models, tip seats vary widely.

2. Thickness

Since the centre hole of the cutting and gouging tip is sized to give the right quantity of oxygen at the right pressure for a specific thickness, the thickness of the metal being cut is crucial.

The pre-heat hole is also sized to hold the right volume of mixed gas to effectively heat a particular metal thickness.

3. Application

Tips are created especially for the uses for which they are intended. For cutting, gouging, and heating, several tips are employed. They could be made out of a single piece of solid copper or a two-piece hybrid made of a copper exterior piece and a brass inside piece. 

For high-pressure cutting that enables quicker, cleaner, and more accurate cuts, some cutting tips are especially made for use with automated cutting equipment.

4. Fuel Gas

Various types of gases are employed in cutting processes. Cutting tips that are specifically created for each type of fuel gas improve how the oxygen and gas are provided.

Things to Keep in Mind:

• Always Stand Aside

Always position yourself to the side of the regulator when slowly opening the cylinder valve. The pressure adjustment (PA) knob and regulator bonnet would be most likely to be hit by the force of the gas in the (very rare) case that the regulator fails. Then, only partially or fully open the acetylene valves while fully opening the oxygen cylinder valve. Alternate fuel cylinder valves should be fully opened.

• Leak Test

All metal-to-metal connections, including those between the gas hoses and the torch, should be tightened using a wrench. Following that, leak test these connections by completely submerging (not soaking, but submerging) them in leak test fluid and keeping an eye out for expanding bubbles. Utilize the approved leak test solution.

• Lighting Alternate Fuels

Hold the flame at a 45-degree angle to the plate if you're having difficulties starting it so the plate "traps" the gas. Once lit, the flame can be put out by adding additional oxygen. If it burns out, relight the torch, set the tip at a 45-degree angle to the plate, and slowly add preheat oxygen until the flame catches.

Conclusion

The greatest after-sales service and heavy industrial equipment are available from OKI Bering, the industrial equipment suppliers in UAE. You can find everything you need to get started, including kits for torch cutting, Victor cutting torch in UAE here right now. Then, for a powerful and reasonably priced torch cutting setup, add some deeply discounted torch tips.